A&D OP-05 Specifikace stáhnout pdf (Strana 71)

Type of Response Description

Acknowledgment

Communication procedure A: Repeats the command as it is.

Communication procedure B: Returns the data.

Communication procedure C: Returns the command as it is

and waits to receive the data.

Negative acknowledgment (Beyond condition): AD-4401 in

non-receiving mode

Negative acknowledgment (Beyond range):

Data format correct, but value beyond allowable range

Negative acknowledgment (Illegal command/data): Command or

data format illegal

Any response is made within 200 ms after receiving the command.

Command Name Function

RW Request-Weight

Reads out the weight; The content of the response data is the same as that set with

RSF-01. Same operation as when the manual print key is pressed.

Data is sent in the “A&D standard format”.

RB Request-Batch-status

Reads out the weighing sequence status; The response data is sent in the

“Output-per-Sampling Format”. The weight output value is the net.

RF Request-Final

Reads out the weighing (Batching) result; Outputs net weight when weighting completes.

Data is sent in the “A&D standard format”.

RT Request-Total

Reads out the accumulated weight and times;

Data is sent in the “Accumulation data format”.

Set Setpoints

Sets the setpoints; Writes 42-character for 7 setpoints altogether. Blanks are filled with 0.

Each value is shown in 6 digit without decimal point. Data is sent in the following format.

RS Request-Setpoint Reads out the Setpoints.; Same format as SS

RE Read-EEPROM

Reads from the EEPROM; Reads the calibration or function data from the EEPROM. The

data equivalent to 206 characters is returned in the ASCII code except the terminators.

If this data is written to another AD-4401 with a “WE” command, calibration and function

settings can be copied.

WE Write-EEPROM Writes to the EEPROM: Same format as the RE command

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 89 90

Žádné komentáře

A&D OP-05 Specifikace Strana 71