A&D OP-05 Specifikace stáhnout pdf (Strana 22)

5-3 CALIBRATION RELATED FUNCTIONS

The calibration related functions are designed to set the basic constants for the indicator. They should be carried out first

thing upon installation.

Step 1 Remove the cover from the calibration switch located at the lower left of the front panel and press the

[CAL] key (found inside). “CAL” is displayed to inform you that the indicator is entering the calibration

mode.

Step 2 Press the [ENTER] key. The indicator switches to the calibration mode and “CAL SEt” is displayed. The

right most digit starts blinking.

Step 3 Press the [

] key. “CAL Fnc” is displayed.

Step 4 Press the [ENTER] key. The indicator switches to the calibration related function mode. The main

display section displays “CALF-01” and the Subdisplay section displays its set value. CALF-01 is the

function for the setting of the unit.

Step 5 Select the function number you want to set, using the [<], [>], [ ∧ ] , and [ ∨ ] keys. The display section

displays a set value for the selected function. In this example, select CALF-02 to set the decimal point

position.

Step 6 In this example; you change the decimal point position to the 10

digit. Press the [ENTER] key. The

Subdisplay section now starts blinking.

Step 7 Press the [

] key. The Subdisplay section displays “1”.

Step 8 Press the [ENTER] key. The main display section starts blinking again and you are returned to selection

of the function number (Step 5).

Step 9 Press the [ESC] key. “CAL SET” is displayed and the settings so far are saved in the EEPROM.

Step 10 This state is the same as in Step 3. Press the [ESC] key once again. The indicator is return to the normal

mode.

The normal mode is restored and the weight value is displayed.

• When “Err” is displayed, the value input exceeds the setting range.

• When “C ErrXX” is displayed, there is an error taking place. See 5-4.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 89 90

Žádné komentáře

A&D OP-05 Specifikace Strana 22