A&D OP-05 Specifikace stáhnout pdf (Strana 55)

CHAPTER 8 INTERFACE

8-1 CONTROL I/O

The Control I/O is intended for inputting/outputting weighing control signals to an external unit. It consists of 6 inputs and

8 outputs.

The capability of each input/output terminal can be selected, except COM (see 6-3, 6-4 for selection method).

Upon shipment, the Control I/O terminals were set for normal batching (Built-in Automatic Program Mode).

TERMINAL FUNCTIONS IN THE BUILT-IN AUTOMATIC PROGRAM MODE

Division

Terminal

No.

Function Name Description

A1 Zero

Clears the gross to zero. However, it does not function beyond the

range set with the calibration

A2 Tare Subtracting the tare weight and a displayed weight becomes the net.

A3 Batch start Starts the weighing sequence.

A4 Emergency stop

Stops charging or discharging and turns on the output terminal set for

the weighing sequence error.

A5 Discharge start Starts the discharging sequence.

Input

A6 Key enable

While this input is ON, the keys disabled by the general function

(FNC-01) are enabled.

A7 Input COM Input COM. Each input is accepted by shorting it with this terminal.

COM

A8 Output COM Output COM

B1 Zero band Turned on when the gross is lower than zero band setting.

B2 Underlimit Turned on when the judgment result is underlimit.

B3 Overlimit Turned on when the judgment result is overlimit.

B4 Full flow Turned on when the weighing sequence is full flow.

B5 Medium flow Turned on when the weighing sequence is medium flow.

B6 Dribble flow Turned on when the weighing sequence is dribble flow.

B7 Discharge Turned on during the discharging sequence.

Output

B8 Batch finish Turned on when the weighing sequence is completed and judged.

CONTROL I/O CONNECTOR, ACCESSORY

Parts Name Q'ty A&D’s parts Number Description

Connector

1 JI-361J016-AG

FCN361J016-AU (or AG),Fujitsu

Connector cover

1 JI-360C016-B

FCN360C016-B, Fujitsu

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 89 90

Komentáře k této Příručce

Žádné komentáře

A&D OP-05 Specifikace Strana 55

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola A&D OP-05