A&D TM-2564G Manuál s instrukcemi stáhnout pdf (Strana 22)

When the battery is used:

1. Remove the power cable from the

electrical outlet.

2. Remove the screw from the battery

compartment cover on the rear of the

instrument.

3. Slide the cover to remove it.

4. Insert the battery connector into the

connector port of the battery

compartment as shown in the illustration.

5. Install the battery as shown in the

illustration, using much care to avoid

damaging the cables. Mate the portion

that the cables come out to the groove of

the battery compartment.

6. Slide the cover to install it.

7. Screw the cover.

Caution

Use the specified battery only.

Switching the power supply

When the AC adapter does not supply power, under the conditions as described below, the instrument

automatically starts battery operation.

 The AC adapter cable is removed from the instrument.

 The power cable is removed from the electrical outlet.

 Power failure

Caution

Power supply is switched automatically. The power supply currently used appears at

the lower right side of the display. Refer to "6-12 Power Supply" for details.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 61 62

Žádné komentáře

A&D TM-2564G Manuál s instrukcemi Strana 22