A&D OP-11 Instalační manuál stáhnout pdf (Strana 78)

2 Operating A&D DataManagement 07/2011

2.4 Specifying the properties of the control components

2-78 SIMATIC A&D DataManagement Client - 07/2011

• Name of the return file

Name of the return file which is used to return the value from the called

application to ADDM. The contents of the return file describe the result of

the action as follows:

[Returncode]#error textwhereby the gate symbol (#) is used as separator.

The value [Returncode] can assume the following values:

<0: Error code of the application.

=0: The action was successfully completed.

=1: The action was successfully completed and there were no

differences.

=2:

The comparison was successfully completed and there were differences.

=3:

Undefined state.

If this field is empty, then after the action has been completed, ADDM

opens a dialog box in which the user must define the comparison result.

• Timeout:

Time in seconds until the action is interrupted.

• Max. no. of backups:

Defines the maximum number for the memory dumps. If this number has

been reached, the next time that a memory dump is created, the oldest

memory dump is overwritten.

• Checkbox: Routed via Agent

By activating this option, the command line of the neutral component is not

executed at the ADDM computer but is routed via "Agent" computer. The

"Agent" computer is defined in the appropriate field by entering the IP

address or the computer name.

Load command

On clicking the button "Load command” the appropriate dialog will be opened.

The command can be defined in the input area. If a command is defined, no direct

disk drive name should be given in within the command line. Another ADDM-Client

(computer) may have a different drive indication for the same drive.

In this case the function is not working, because the drive name will be not found.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 181 182

Žádné komentáře

A&D OP-11 Instalační manuál Strana 78